Skip to content

(CA-US) FREE SHIPPING ON ORDERS $120+ BEFORE TAXES

Instructions

Installation guide Oversized decals

Large Format Sticker Installation

Large format wall stickers require a more gradual installation than small stickers. Prepare a clean, smooth, and dry surface, then confirm the location before completely removing the backing.

Ideally, work with two people. Align the top, gradually peel off the backing, and smooth as you go to avoid bubbles and creases. Take your time to maintain a straight and even finish.

Shop: wall stickers · bedroom decor · living room decor

Required materials

Dry, clean cloth
Painter's tape
Scissors

Adequate surfaces

Smooth, dry, and clean surface, covered with one coat of primer and one or two coats of paint.

Please wait a minimum of 15 days before installing on a freshly painted surface.

Surfaces to avoid

Dirty, moldy or dusty surface

Textured, damaged or peeling surface

*it is not recommended to install directly on brick, wood, drywall, primer or plaster

Watch our installation video

Watch the video
Hand with rag cleaning wall

1. Prepare the surface

The surface must be completely smooth, clean and dry. Feel free to remove any dust with a slightly damp cloth. Make sure there are no residues on the wall, such as paint runs. Sanded surfaces must be impeccable, as imperfections could be visible. If the paint is fresh, wait at least two weeks before proceeding with the installation.

Sticker installed on the wall with adhesive tape

2. Prepare the installation
It is best to proceed with 2.

Place the decal on the wall with painter's tape to visualize its placement.

Shears that cut the back film

3. Stick the top of the sticker

Once the decal is in its final position, peel back about 2 inches of the backing film and cut it off. Then, attach this part to the wall by pressing and sliding with your hands. Once the top of the decal is securely attached to the wall, you can remove the adhesive tape.

Gradual removal of the back film

4. Remove the back film

Gradually peel off the backing film while smoothing the sticker onto the wall with your hands. Make sure to remove any air bubbles by pushing them towards the edges.

Main finishing the sticker application

5. Remove air bubbles

If air bubbles are still present, try to push them outwards. Otherwise, use a needle to prick them.

View or download our PDF

See PDF

What are you looking for?